From the Manufacturer The new PM15 from Powermatic is loaded with features
that make it a standout. Large 5HP motor gives the unit 15" wide
planing capacity and enough power to run double knife sets for molding.
The stand is fully enclosed and is equipped with integral casters for
shop mobility. Two feed speeds, 10 and 20 fpm’s allow you to run
quickly for maximum stock removal yet slower speeds yield a fine milled
finish on decorative moldings. Opening the hinged top with 4" dust
collection port exposes the cutterhead, allowing for fast and easy
tooling changes. This machine can use either single molding knives or 3
knife sets, whichever you choose. A long list of available accessories
will make this machine a valuable addition to any shop.
Features:
5 HP motor with
15" planing capacity handles the biggest jobs
Fully enclosed
cabinet with integral cabinet for complete shop mobility
Feed rollers and
cutterhead supported by full cast-iron head assembly
Uses single or 3
piece molding knives for a wide selection of available
profiles
Large 27-1/2-
by-15-1/8-inch cast iron table for material support
